Intermec SR60 User Manual

The following table describes the commands that the RS-232  
interface accepts from the host.

Disable 
Scanner

D

Places the scanner in an operational 
mode in which the scanner does not 
accept bar code data input from the 
scan optics. 
The scanner will complete any message 
transmission in progress to the host.

Enable 
Scanner

E

Places the scanner in an operational 
mode in which the scanner will accept 
label data input from the scan optics.

Reset 

 

Scanner

R

Performs a scanner reset operation.  
Any bar code data the scanner may be 
holding in buffers is discarded. 
After the reset is executed, additional 
host commands may be ignored for 
thirty seconds.

Beep Good 
Read Tone

B

Causes the beeper to sound one good 
read tone if the beeper is enabled.
For help configuring the beeper, see 
“Configuring the Beeper Settings” on 
page 134.

Force Good 
Read Tone

01

Causes the beeper to sound one good 
read tone even if the beeper is disabled.

XOFF

11

Suspends current data transmission 
from the scanner to the host or 
prevents future data transmissions 
from occurring.

XON

13

Permits resumption of data 
transmission from the scanner to the 
host that was previously suspended via 
the XOFF command.