Intermec SR60 User Manual

The amber Laser On LED is located on top rear of the scanner 
and lights whenever laser power is on.

The green Good Read LED is located on top rear of the scanner 
and flashes:

• once to indicate when a good read has occurred.

• slowly on and off to indicate the scanner is in Programming 

mode.

The beeper operates differently when the scanner is in Scanning 
mode and in Programming mode.

• When the scanner is in Scanning mode, the beeper sounds:

• four times at power-up.

• once following a good read.

• six rapid chirps to indicate an error (error tone).

• When the scanner is in Programming mode, the beeper 

sounds:

• once when entering or exiting Programming mode.

• three times to indicate a successfully programmed feature.

• an error tone if you scan programming bar codes for 

features that are not compatible with the current interface. 
For example, you can set baud rate and parity only when 
the current interface is RS-232.

Your scanner must be equipped with the correct hardware to 
properly communicate with your host system. Contact your local 
Intermec representative if you have questions about your scanner 
hardware compatibility. 

Intermec offers the following interface cables for the SR60 
scanner:

• Wand emulation

• RS-232