Intermec SR60 User Manual
Chapter 2 — Configuring Interface Settings
SR60 Scanner Programmer’s Reference Manual
17
Wand Emulation Pre/Post-Noise Settings
You can independently configure the number of noise transitions
generated prior to or following label transitions.
generated prior to or following label transitions.
To disable transmitting pre-noise or post-noise transitions
1
Scan the SET bar code.
2
Scan either the Don’t Transmit Pre-Noise bar code on page 17
or the Don’t Transmit Post-Noise bar code on page 18.
or the Don’t Transmit Post-Noise bar code on page 18.
3
Scan the END bar code. You have disabled noise transitions.
To set pre-noise or post-noise transitions
1
Scan the SET bar code.
2
Scan either the Set Pre-Noise Transitions bar code on page 17
or the Set Post-Noise Transitions bar code on page 18.
or the Set Post-Noise Transitions bar code on page 18.
3
From the “Keypad Bar Codes” on page 154, scan two digits
that represent the appropriate number of noise transitions.
You can choose from one to twenty noise transitions for either
pre-noise or post-noise. For example, scan the 0 and the 3 bar
codes for three transitions.
that represent the appropriate number of noise transitions.
You can choose from one to twenty noise transitions for either
pre-noise or post-noise. For example, scan the 0 and the 3 bar
codes for three transitions.
4
Scan the END bar code.
Pre-Noise Transitions Settings
SET -------------------------------------------
Don’t Transmit Pre-Noise ---------
Set Pre-Noise Transitions ---------