Intermec SR60 User Manual
Chapter 3 — Configuring Label Transmit Settings
52
SR60 Scanner Programmer’s Reference Manual
Setting a Single-Character Prefix or Suffix
The scanner does not transmit a prefix or suffix character if its
hex value is set to zero.
hex value is set to zero.
To set a prefix or suffix that has only one character
1
Using the ASCII chart on page 158, identify the ASCII
character and the corresponding hex code for the single-
character prefix or suffix.
character and the corresponding hex code for the single-
character prefix or suffix.
For example, suppose you want to use the Space (SP)
character. The ASCII charts shows that SP equals 20 hex.
character. The ASCII charts shows that SP equals 20 hex.
2
Scan the SET bar code on page 53.
3
Scan the Set Prefix or Set Suffix bar code.
4
Using the list of bar codes that starts on page 154, scan the
two digits corresponding to the hex value you chose in Step 1.
two digits corresponding to the hex value you chose in Step 1.
5
Scan the 0 digit twice to disable the transmission of a second
character.
character.
6
For this example, you would scan 2, 0, 0, and 0.
7
Scan the END bar code.
END ------------------------------------------
Note: Successful programming requires four digits for the
label ID.
label ID.
Note: If you make a mistake or lose your place while setting
this option, scan the END bar code to exit Programming
mode. The scanner sounds a two-beep error tone to indicate
that programming was incomplete, and the setting remains as
it was before entering Programming mode.
this option, scan the END bar code to exit Programming
mode. The scanner sounds a two-beep error tone to indicate
that programming was incomplete, and the setting remains as
it was before entering Programming mode.