Intermec SR60 User Manual
Chapter 3 — Configuring Label Transmit Settings
SR60 Scanner Programmer’s Reference Manual
63
6
Scan the END bar code.
Disabling a Symbology-Specific Label ID
To disable a symbology-specific label ID, you follow the steps in
the “To set a single-character label ID” procedure on page 62,
except you must scan four zeros in Step 5.
the “To set a single-character label ID” procedure on page 62,
except you must scan four zeros in Step 5.
Note: If you make a mistake or lose your place while setting
this option, scan the END bar code to exit Programming
mode. The scanner sounds a two-beep error tone to indicate
that programming was incomplete, and the setting remains as
it was before entering Programming mode.
this option, scan the END bar code to exit Programming
mode. The scanner sounds a two-beep error tone to indicate
that programming was incomplete, and the setting remains as
it was before entering Programming mode.