Panasonic KV S1020C User Manual
Setting up the Scanner
12
Power turn-on sequence
1
Turn on the power of the scanner.
• Connect the power cord to the AC adaptor.
• Connect the AC adaptor to the scanner.
• Plug into an AC outlet.
• Push the power switch.
• The LED (Green) will blink for about 30
seconds and then it will become steady.
Note:
• Install the software first.
About LED
The status of the scanner can be established by the condition of the two LED indicators shown in the table below:
*1
The scanning lamp(s) periodically lights up in sleep mode. This is not an unusual event.
For details on sleep mode, refer to the User Utility Reference Manual.
For details on sleep mode, refer to the User Utility Reference Manual.
*2
It will take about 30 seconds to initialize the scanner.
LED (
Green
)
LED (
Red
)
Status
ON
OFF
Ready
Blink (Slow)
OFF
Sleep
*1
ON
Blink (Slow)
Warning
Blink (Slow)
Blink (Slow)
Warning/Sleep
ON
ON
Error
Blink (Fast)
OFF
Warming up
*2
AC adaptor
Power cord
Power switch (
)
USB cable
Ready
Error
Start / Stop
LED (
Green
)
LED (
Red
)