Symbol Technologies DS 3408 User Manual
Scanning
2-5
LED Definitions
In addition to beep sequences, the digital scanner uses a two-color LED to indicate status.
defines LED colors that display
during scanning.
Hi/Hi beeps
Enter another criterion or action, or scan the Save Rule bar code.
Hi/Lo/Hi/Lo beeps
Rule saved. Rule entry mode exited.
Hi/Lo/Lo beeps
All criteria or actions cleared for current rule, continue entering rule.
Low beep
Delete last saved rule. The current rule is left intact.
Lo/Hi/Hi beeps
All rules are deleted.
ADF Programming: Error Indications. Duration of tones are very long.
Lo/Hi/Lo/Hi beeps
Out of rule memory. Erase some existing rules, then try to save rule again. (It is not necessary to re-enter the current
rule.)
rule.)
Lo/Hi/Lo beeps
Cancel rule entry. Rule entry mode exited because of an error or the user asked to exit rule entry.
Lo/Hi beeps
Entry error, wrong bar code scanned. Re-enter criterion or action. All previously entered criteria and actions are
retained. Criteria or action list is too long for a rule.
retained. Criteria or action list is too long for a rule.
Host Specific
USB only
4 short high beeps
Digital scanner has not completed initialization. Wait several seconds and scan again.
Short low/short medium/short high
beep sequence after scanning a USB
device type
beep sequence after scanning a USB
device type
Communication with the bus must be established before the digital scanner can operate at the highest power level.
Short low/short medium/short high
beep sequence occurs more than once
beep sequence occurs more than once
The USB bus can put the digital scanner in a state where power to the digital scanner is cycled on and off more than
once. This is normal and usually happens when the PC cold boots.
once. This is normal and usually happens when the PC cold boots.
RS-232 only
1 short high beep
A <BEL> character is received and Beep on <BEL> is enabled.
Table 2-2. Standard LED Definitions
LED
Indication
Off
No power is applied to the digital scanner, or the digital scanner is on and ready to scan.
Green
A bar code was successfully decoded.
Red
A data transmission error or digital scanner malfunction occurred.
Table 2-1. Beeper Definitions (Continued)
Beeper Sequence
Indication