PSC 1400I User Manual

General Features

This feature sets the time after the last label segment is seen before the scanner prepares for a 
new label.

This setting specifies how long the 

 timer runs when specifically collecting 

PDF label segments prior to discarding data.

START / END

PROGRAMMING BAR CODES

Sets the label gone timeout duration using hex values from 000 to 255 in increments of ten milliseconds (10ms or 0.01 seconds). To 
configure this feature, scan the “START/END” bar code above to place the unit in Programming Mode, then the “Set Label Gone Tim-
eout,” followed by three digits (zero padded) from the Alphanumeric table in 

desired time value. Exit programming mode by scanning the “START/END” bar code again.

Set Label Gone Timeout

START / END

PROGRAMMING BAR CODES

Sets the label gone timeout duration using hex values from 001 to 255 in increments of ten milliseconds (10ms or 0.01 seconds). To 
configure this feature, scan the “START/END” bar code above to place the unit in Programming Mode, then the “Set PDF Label Gone 
Timeout,” followed by three digits (zero padded) from the Alphanumeric table in 

 representing the 

desired time value. Exit programming mode by scanning the “START/END” bar code again.

Set PDF Label Gone Timeout