Radio Shack PRO-107 User Manual

Battery Notes:

• A low battery warning sounds every 30 seconds (default setting)

when the batteries are nearly depleted.

• Dispose of batteries promptly and properly. Do not burn or bury

them.

• Use only fresh batteries of the required size and type.
• Do not mix old and new batteries, different types of batteries

(standard, alkaline, or rechargeable), or rechargeable batteries of

different capacities.

• Discontinue use of any battery that exhibits leakage, swelling, or

abnormal generation of heat.

• If you do not plan to use the iSCAN for a month or longer,

remove the batteries. Batteries can leak chemicals

that can damage electronic parts.

Using AC Power

1. Press and hold to power off iSCAN.
2. Plug the mini-USB end of the supplied USB cable

into the PC/IF jack and connect the USB end to a
USB power source, such as your computer or an AC
USB power adapter (not included, available at your
local RadioShack or RadioShack.com).

3. Slide Main Power Cut-Off to the ON position.
4. Press and hold to power on iSCAN.

Notes:

• Some USB power adapters generate RF noise that

can interfere with iSCAN’s reception.

• To prevent corruption of SD card data, always

power off iSCAN using before connecting or
disconnecting external power sources.

• External electric power is supplied to the iSCAN

through USB bus power (DC 5V 500mA).

Using Vehicle Power

1. Press and hold to power off iSCAN.
2. Plug the mini-USB end of the supplied USB cable into the PC/IF

jack and connect the USB end to a car DC USB power adapter (not
included, available at your local RadioShack or RadioShack.com).

3. Slide Main Power Cut-Off to the ON position.
4. Press and hold to power on iSCAN.

Note: If you use a cigarette-lighter USB power cable and your

vehicle’s engine is running, you might hear electrical noise from the
engine while scanning. This is normal.

Charging Ni-MH Batteries

1. Press and hold to power off iSCAN.
2. Make sure Ni-MH batteries are installed and the Battery Type

Selector switch is set to NI-MH.

3. Plug the mini-USB end of the USB cable into the PC/IF slot

and connect the USB end to a USB power source, such as your
computer or an AC USB power adapter.

4. The animated battery icon indicates the batteries are being

charged.

5. When appears instead of

, the batteries are fully charged.

High-capacity batteries may take up to 16 hours to charge.

6. Disconnect iSCAN from the power source.

Notes:

• You can use iSCAN while charging batteries, but it is not

recommended. The charging current decreases and charging
time becomes long.

• Do not over-charge rechargeable batteries. Overcharging

shortens battery life.

PC/IF

Lift

cover