Canon Model 6401 B User Manual
Field Test Unit Software
• Batteries (AA x 4)
• Model 6602E cable to connect FTU to Data Logger
• Model 6401D Mains Power Pack
• Prom with STARLOG Software (already installed)
• Reference Card for (FTU)
1.2.3 Switching on the FTU
Ensure that the batteries have been inserted and that the Lock Switch (slide
switch, underneath) is in the ON position, then press the ON/BREAK key.
The FTU should power on and the following appear on the screen :
The FTU should power on and the following appear on the screen :
Copyright(c) 1983 by
Microsoft & Canon
14940 Bytes free
Microsoft & Canon
14940 Bytes free
Note, however, that the number of Bytes free may differ from the above as
it depends on the size of the file area that has been set (the size of the file
area can be changed)
it depends on the size of the file area that has been set (the size of the file
area can be changed)
1.2.4 Running a Program
To run a program, use the BASIC command :
RUN"filnam"
where filnam is the name of the file you wish to run.
1.3 CASSETTE STORAGE
Cassettes may be used for long term storage of Programs and data. It is ad-
visable to keep a copy of programs on cassette, as the contents of the file
area may sometimes be destroyed.
visable to keep a copy of programs on cassette, as the contents of the file
area may sometimes be destroyed.
1.3.1 Attaching the cassette
The cassette cable plugs into the small round DIN-type socket on the right
hand side of the FTU. The other end of the cable has three pIugs. These
should be plugged into the cassette recorder as follows:
hand side of the FTU. The other end of the cable has three pIugs. These
should be plugged into the cassette recorder as follows:
RED
MIC (Input)
Section 1. INTRODUCTION
3