Sony DASK-S704 User Manual
12
(GB)
Sampling
After the microphone input level has been adjusted in rehearsal, perform
sampling of the reverberation.
sampling of the reverberation.
Note
The background noise in the sampling space will be recorded over the
reberveration. When sampling, choose a situation with as little
background noise as possible. If noise occurs during sampling, i.e. noise
from a plane, car, human voice, bird voice, etc., retry sampling from the
beginning.
reberveration. When sampling, choose a situation with as little
background noise as possible. If noise occurs during sampling, i.e. noise
from a plane, car, human voice, bird voice, etc., retry sampling from the
beginning.
1
Confirm the sampling conditions on the initial display of the DASK-
S704.
If necessary, change the conditions on the SETUP display.
S704.
If necessary, change the conditions on the SETUP display.
SAMPLE
Enter
Rehearsal
Sampling
Compile
Change MS
Compile
Change MS
MS:xxxxxxxx 24MB Available
Fs/Period=Fs/5.5sec
Repeat =16
Input =AD
Clock =Internal 48.0 kHz
Fs/Period=Fs/5.5sec
Repeat =16
Input =AD
Clock =Internal 48.0 kHz
Sampling frequency and period: Normally set to Fs/5.5sec or 2Fs/
5.5sec. When sampling in a space with a long reberveration time
such as a church, set it to Fs/11sec and perform sampling. Compile
the sampled data once to check the sampling result, then check if
the setting is to be changed or not.
such as a church, set it to Fs/11sec and perform sampling. Compile
the sampled data once to check the sampling result, then check if
the setting is to be changed or not.
Sampling repeat times: Normally set to 16. When sampling outdoors
where there is usually much background noise, perform sampling
with the setting at 16, compile the sampled data once to check the
sampling result, then check if the setting is to be changed or not.
Set to 1 when sampling digital reverb sound or when noise level
reduction by the synchronized addition is not required.
with the setting at 16, compile the sampled data once to check the
sampling result, then check if the setting is to be changed or not.
Set to 1 when sampling digital reverb sound or when noise level
reduction by the synchronized addition is not required.
Note
The DABK-S703 expansion DSP (optional) is required when sampling
with the Fs/11sec or 2Fs/5.5sec setting.
with the Fs/11sec or 2Fs/5.5sec setting.
For setting on the SETUP display, see page 27.
2
Turn the jog dial to highlight “Sampling.”
SAMPLE
Enter
Rehearsal
Sampling
Compile
Change MS
Change MS
MS:xxxxxxxx 24MB Available
Fs/Period=Fs/5.5sec
Repeat =16
Input =AD
Clock =Internal 48.0 kHz
Fs/Period=Fs/5.5sec
Repeat =16
Input =AD
Clock =Internal 48.0 kHz
3
Press the F4 key.
“Loading CDROM/MS” is displayed, then “Start sampling?” appears.
“Loading CDROM/MS” is displayed, then “Start sampling?” appears.
SAMPLE
Enter
Exit
Rehearsal
Sampling
Compile
Change MS
Change MS
Start sampling ?
Sampling repeat times
Sampling frequency and period