Pelco C1902M (11/96) User Manual
14
Pelco Manual C1902M (11/96)
5.0 CAMERA INSTALLATION
ATTENTION: Installation should be per-
formed by qualified service personnel only, in
accordance with the National Electrical Code
or equivalent/applicable local codes.
formed by qualified service personnel only, in
accordance with the National Electrical Code
or equivalent/applicable local codes.
When attaching the camera to a ceiling bracket or tri-
pod, attach the supplied mounting bracket. The bracket
may be attached to either the top or bottom of the cam-
era. Use the supplied 1/4" UNC-20 screw to attach the
camera to the tripod or ceiling bracket.
pod, attach the supplied mounting bracket. The bracket
may be attached to either the top or bottom of the cam-
era. Use the supplied 1/4" UNC-20 screw to attach the
camera to the tripod or ceiling bracket.
5.1 Connections (Illustration
F
)
Using an internal synchronization signal.
Set the L.L/INT switch to “INT” (internal synchro-
nization).
nization).
Connect with VIDEO OUT connector.
75-ohm coaxial cable
Connect with VIDEO IN connector on a video
monitor, etc.
monitor, etc.
To power supply (CC4600-2, CC4600-2X); to a
wall outlet (CC4600-3)
wall outlet (CC4600-3)
Power cord
4
1
3
7
F
3
4
2
1
7
6
5
4
3
2
6
5
CC4600-2 & -2X
CC4600-3
2
5
Connecting the CC4600 Series Cameras
1
2
3
4
To AC 24V terminals 1 and 2 (CC4600-2,
CC4600-2X)
CC4600-2X)
When using an external (L.L) synchronization signal,
set the L.L/INT switch (1) to L.L and make connec-
tions as above.
set the L.L/INT switch (1) to L.L and make connec-
tions as above.
CAUTION: Be sure cable wires
are routed so as to not pinch or rub
when connected to pan/tilt units.
Frayed, pinched or broken wires
can cause fire/shock hazards or
system failure.
are routed so as to not pinch or rub
when connected to pan/tilt units.
Frayed, pinched or broken wires
can cause fire/shock hazards or
system failure.
5.2 Phase Adjustment (Illustration
G
)
When using more than one camera, connect to a cam-
era switcher and set the vertical phase range as follows:
era switcher and set the vertical phase range as follows:
Camera switcher
Vertical phase
Monitor
Adjustable range
6