OmniTek 2.3 User Manual

The Region of Interest toolbar is a control window that acts in conjunction with the 
Waveform and Vector Scope windows, and provides fine detail control over the part of 
the video frame that is used to create waveforms etc. It is described on page 63, 
alongside the description of the Waveform and Vector Scope windows. 

 

The Run toolbar is available where OmniTek XR includes the Motion-Capture option. 
However the transport options are only activated if either a sequence or the playlist is 
active within the Generator window. 

Transport Controls 

  Go to 1

st

 frame of the Clip/Sequence 

 

Step back in the clip by one frame 

 

Play the clip in reverse. Note that this reverses the order of the frames, but not the fields. 

  Stop playing the sequence 

 

Play the clip forwards 

  Step forwards in the clip by one frame 

  Go to the last frame of the clip 

 

Enable Loop mode (for playing a sequence) 

 

Frame 

The  Frame box lets you select an individual frame from the sequence for immediate 
display. 

Play Speed 

The Play Speed box lets you choose a playback speed for the sequence. This can be 
real time, quarter speed, half speed or double speed.  

The following two icons are concerned with the Time Shift feature, which is only active 
where the system includes the Advanced Option package.  

Time Shift provides the useful facility to trigger a video capture only if a specified error 
condition occurs, and further to record the frames immediately before the event as well as 
after the event. Captured video can then be reviewed or stored to disk for later review.  

 

Enter Time Shift mode and wait for a trigger. 

 

Time Shift Configuration. This brings up the Time Shift dialogue shown below.