Bosch VDx-244 Leaflet

Guide pattern

Mounting anchors

Rubber pad

Inner dome

Key

Dome base

4 mounting screws

Dome cover

139 (5.47)

54.2 (2.13)

13.3 (0.52)

34.5 (1.35)

102.0 (4.01)

100.2 (3.94)

51.7 (2.03)

13.8 (0.54)

51.7 (2.03)

13.8 (0.54)

51.7 (2.03)

13.8 (0.54)

51.7 (2.03)

mm (in)

13.8 (0.54)

4– Ø4.4±0.1

PT 1/2" TAP

PT 1/2" TAP

BNC 
female

1 Vpp
75 Ohm

not included

24 VAC /
12 VDC
Class 2

LEF

T

UP

RIGHT

LL

INT

Menu (set)

High risk: This symbol indicates an imminently hazardous 

situation such as "Dangerous Voltage" inside the product.

If not avoided, this will result in an electrical shock, serious 

bodily injury, or death.

Medium risk: Indicates a potentially hazardous situation.

If not avoided, this could result in minor or moderate bodily 

injury.

Low risk: Indicates a potentially hazardous situation.

If not avoided, this could result in property damage or risk of 

damage to the unit.

The Low Voltage power supply unit must comply with EN60950 

/ UL60065. The power supply must be a SELV-LPS unit or a 

SELV - Class 2 unit (Safety Extra Low Voltage - Limited Power 

Source). 

Installation should only be performed by qualified service 

personnel in accordance with the National Electrical Code or 

applicable local codes.

1.

Read these instructions.

2.

Keep these instructions.

3.

Heed all warnings.

4.

Follow all instructions

5.

Clean only with a dry cloth.

6.

Install in accordance with the manufacturer's instructions.

7.

Do not install unit near any heat sources such as radiators, 

heat registers, stoves, or other apparatus (including 

amplifiers) that produce heat.

8.

Protect the power cord from being walked on or pinched 

particularly at plugs, convenience receptacles, and the 

point where they exit from the apparatus.

9. Only use attachments/accessories specified by the 

manufacturer.

10. Unplug this apparatus during lightning storms or when 

unused for long periods of time.

11. Refer all servicing to service personnel. Servicing is 

required when the apparatus has been damaged in any 

way, such as power-supply cord or plug is damaged, liquid 

has been spilled or objects have fallen into the apparatus, 

the apparatus has been exposed to rain or moisture, does 

not operate normally, or has been dropped.

This equipment has been tested and found to comply with the 

limits for a 

Class B digital device, pursuant to 

part 15 of the 

FCC Rules. These limits are designed to provide reasonable 
protection against harmful interference in a 

environment. This equipment generates, uses, and can radiate 

radio frequency energy and, if not installed and used in 

accordance with the instructions, may cause harmful 

interference to radio communications. However, there is no 

guarantee that interference will not occur in a particular 

installation. If this equipment does cause harmful interference 

to radio or television reception, which can be determined by 

turning the equipment off and on, the user is encouraged to try 

to correct the interference by one or more of the following 

measures:

–

reorient or relocate the receiving antenna;

–

increase the separation between the equipment and 

receiver;

–

connect the equipment into an outlet on a circuit different 

from that to which the receiver is connected;

–

consult the dealer or an experienced radio/TV technician 

for help.

Intentional or unintentional modifications, not expressly 

approved by the party responsible for compliance, shall not be 

made. Any such modifications could void the user's authority to 

operate the equipment. If necessary, the user should consult 

the dealer or an experienced radio/television technician for 

corrective action.

Optical elements are sensitive and should be protected at all 

times. Do not allow objects to come into contact with glass 

surfaces and do not touch optical elements with your fingers.

This manual is the intellectual property of Bosch Security 

Systems and is protected by copyright.

All rights reserved.

All hardware and software product names used in this 

document are likely to be registered trademarks and must be 

treated accordingly.

Bosch Security Systems accepts no liability for damage 

resulting directly or indirectly from faults, incompleteness or 

discrepancies between the user guide and the product 

described.

For more information please contact the nearest Bosch Security 

Systems location or visit 

Disposal - Your Bosch product was developed and 

manufactured with high-quality material and components that 

can be recycled and reused. This symbol means that 

electronic and electrical appliances, which have reached the 

end of their working life, must be collected and disposed of 

separately from household waste material. Separate collecting 

systems are usually in place for disused electronic and 

electrical products. Please dispose of these units at an 

environmentally compatible recycling facility, per 

AM18-Q0642

1/2