Bosch 3922 988 43318 User Manual
2
Bosch Security Systems | 04-2003 | 3922 988 43318 en
Digital Congress Network | Installation and Operating Manual | Chapter 11 - System Set-up and Operation
en | 11-21
Programming the Interpreter desk
11.11.2 Entering the desks programming mode
Before attempting to program the interpreter desk, ensure that the system has first been initialized
(see
(see
Initializing). If the system has been initialized and the display shows ‘DESK NOT
INSTALLED‘ ,the desk is ready to be programmed.
NOTE:
Only one desk can be programmed at the same time.
To enter the desk in to its “
Programming
” mode proceed as follows::
1. Press the key ‘
Pre-select b
’ and the ‘
Outgoing B
’ keys simultaneously.
The Installation mode is shown as follows:
NOTE:
Due to the length of the opening message, the message is displayed over additional
screens. The message in full is as follows:
11.11.3 Menu Programming procedures
STEP 1.
Press the ‘
B-Select
’ up/down keys < > to scroll through and select the required
Installation menu.
STEP 2.
Once in the chosen menu, rotate the ‘
Relay select
’ knob (left, up, right, down) to high-
light the required selection. Arrow brackets <..> highlight the chosen entry. If this
function is not available, press the ‘
function is not available, press the ‘
Mute
’ key to clear a previous setting.
A previous setting is displayed with square brackets [..].
STEP 3.
To input and confirm the selected entry, press the ‘
Floor
’ key. Once entered, the
selected entry is surrounded with square brackets [..].
STEP 4.
Press the ‘
Mute
’ key to clear a previous settings. Pressing this key throughout the
programming mode allows a previous settings to be cleared, ready for new input data
and errors to be corrected.
and errors to be corrected.
* * * * * * * DESK NOT INSTALLED * * * * * * *
Installation mode, press ‘Floor’ to
enter or ‘Mute’ to clear, use ‘Select’
knob to select option and B - select ‘<>’
keys to select next or previous function
Installation mode, press ‘Floor’ to enter or
‘Mute’ to clear, use ‘Relay select’ knob to
select option and B-select ‘<>’ keys to
select next or previous function.