Samsung RFG296HDRS User Manual

 

setting up

To prevent floor damage, be sure the front 
adjusting legs are in the up position

(above the floor). Refer to ‘Adjusting the doors’ in the 
manual (on page 9).

FLOORING
For proper installation, you must place this refrigerator
on a level, hard surface that is the same height as the 
rest of the floor.  
This surface should be strong enough to support a 
fully loaded refrigerator. 
To protect the finish of the flooring, cut a large 
section of the cardboard carton and place it under 
the refrigerator where you are working. When moving 
the refrigerator, you need to pull and push it straight 
forwards or back. Do not wiggle it from side to side.

ACCESSORIES AND REQUIRED 
TOOLS

The following accessories are included with your 
refrigerator:

You need the following tools to complete the 
installation of your refrigerator:

REMOVING THE REFRIGERATOR DOORS

For some installations you need to remove the fridge
and freezer drawers so you can move the refrigerator to its 
final location. Do not remove the doors/drawer if you don't 
need to. If you do not need to remove the refrigerator 
doors, go to Adjusting the Level on page 8. If you need to 
remove the doors. continue below. Before removing the 
door/drawer, make sure you read the following items:

Disconnect power to the refrigerator before 
removing the door or drawer.

•  Be careful not to drop, damage or scratch the 

door/drawer while removing them.

•  Be careful not to get injured while removing the 

door/drawer.

•  Reattach the door/drawer properly to avoid: 
-   Moisture from air leakage.
-   Uneven door alignment.
-  Wasting energy due to improper door seal.

Be careful not to drop and scratch the doors 
while removing the doors.

1.   With the door opened, remove the cap top table        

( 

1 ) with a flat-blade screwdriver(-). and close the 

door. Remove 2 screws holding down the cover 
hinge ( 

2 ) and turn it with several wires connected.

CAUTION

WARNING

WARNING

Flat-blade 
screw driver(-)

Control Lever

Hex wrench

Fastener

Philips 

screwdriver(+)

Flat-blade screw 

driver(-)

Socket wrench 

(10mm)

Pliers

Allen wrench

(3/16”) (5mm)

1

2

DA68-02488A-11.indb   6

14. 5. 14.   �� 11:45