Beko GNE 60520 DX User Manual

EN

11

1

2

A pump should be used for bottle 

water usage.
Check that the parts stated below are 

supplied with your appliance.
1.  Union for connection of the water 

pipe to the rear of the appliance. 

(If it does not fit, provide it from the 

nearest authorized service.)

2.  2 pieces of pipe clips (In case 

required to secure the water pipe)

Note: Since the following parts are 

not required in use with a bottle, they 

may not be found in the product you 

purchased.
3.  5-meter long water pipe (1/4 inch in 

diameter)

4.  Cold mains water valve with mesh 

filter (Tap Adapter)

5.  Water Filter or externally connectable 

filter to be fitted to the bracket inside 

the fridge compartment.

Place where the external filter is going 

to be fitted should be determined 

first. (Applies to the filter being 

used outside the refrigerator.) Then, 

determine the distance between the 

filter and the refrigerator and required 

hose lengths from the filter to the 

refrigerator water inlet.

Water filter must be hold upright as 

shown in the figure. It is important to 

properly attach the filter to water inlet 

and water outlet points.

After attaching the filter, do not use first 

3-4 glasses of water.

1. After installing the union onto the 

water pipe, insert the water pipe to 

the refrigerator inlet valve by pressing 

downwards firmly.
2. Fix union as seen in the opposite 

figure, by squeezing by hand on the 

refrigerator inlet valve.
(a- Water Pipe, b-Union, c-Valve)

C

 Note 1: You should not need to 

tighten the union with a tool to achieve 

water tight assembly. In case of a leak 

use a spanner or a pair of pliers to 

tighten the union.