Tandberg Data T40 User Manual

 

StorageLibrary Installation and User Guide 

5 

 

Issue operational commands. 

 

View StorageLibrary status and information. 

 

Test StorageLibrary functionality. 

The labels for the four control buttons are displayed in the corners of the LCD. All buttons have  soft 
function  for different modes of operation, i.e. the functions of the buttons change during different 
activities. The actual function for each button is always visible on the display. 

The two LED indicators are green and amber. They indicate the StorageLibrary activity as follows: 

 

Green LED on: The StorageLibrary is either running or ready for operation.  

 

Green LED blinking: Short blinks followed by long intervals indicate that the library is in low power 
standby mode. 

 

Amber LED on: Fault LED; the StorageLibrary has encountered an electrical or mechanical 
failure. 

A switch on the front panel provides a Library Standby mode. If the switch is pushed when the library 
is active, the library completes the current operation and then goes offline and enters standby mode. 
See 

Standby Functionality

 

for more details. 

Rear Panel 

The figure below shows the rear panel of the StorageLibrary. 

Figure 2. Rear Panel of the StorageLibrary with 1 Full-Height SCSI Drive Installed   

   

Forced-air cooling fans are integrated in both the power supply, the tape drive, and behind the library 
control board. The fans draw air inward through holes in the front bezels and expel it out the back. 
The fans start whenever the drive is operating or when the internal temperature in the StorageLibrary 
gets too high.  

Main power switch, 

power outlet  

and fuse

 

Back panel 

cover plates

 

SCSI 

connectors 

Emergency eject tool. 

(RTC battery and drive 

power extension cable 

behind cover.) 

Ethernet 

connector

 

Tape drive 

with fan 

Power supply 

 with fans 

 

Cooling fans