Tandberg Data T40 User Manual

 

22  

Information about the Operator Interfaces 

Remote Management Interface 

The remote management interface is similar to the front panel interface. The remote management 
interface is accessible from any supported web browser. For more information on supported web 
browsers, refer to 

Browser Requirements

. To manage the library from a remote management 

interface, you must set up the library s initial network configuration from the front panel. For 
information on network configuration settings for remote use, refer to 

Configuring Network Settings

. 

Menu Trees 

The following four menus organize commands into logical groupings: 

 

The Operations menu consists of commands that enable you to change the library s mode of 
operations, import and export cartridges, load and unload tape drives, eject magazines, clean 
drive and change partition mode. 

 

The Setup menu consists of commands that you can use to set up and configure various aspects 
of the library, including network, partitions, I/E stations, cleaning slots, drive configuration, license, 
password, menu timeout, date and time, barcode scan, and audible alarm. 

 

The Reports menu consists of summaries of the values assigned during library setup. It also 
includes viewing of RAS tickets and diagnostic logs.  

 

The Tools menu consists of commands that you can use to maintain your library such as restore 
default settings, reboot, prepare for shipping, update firmware, and run system tests. 

Figure 14 Front Panel Interface Menu Tree

 and 

Figure 15 Remote Management Interface Top Level

 

Menu Tree

 give an overview of the menus on the front panel and the remote management interface. 

Table 2. Front Panel Interface Menu Structure

 

and 

Table 3. Remote Management Interface Menu

 

Structure

 

describe the same menus but with more details.