La Crosse Technology TX7U User Manual

Page of 5
5. 
Snap the outdoor temperature/humidity sensor into 
place on the mounting bracket. 
 
B. 
MOUNTING WITH ADHESIVE TAPE 
 
1. 
With a nonabrasive solution, clean and dry the back of 
the mounting bracket and the mounting surface to 
ensure a secure hold. The mounting surface should be 
smooth and flat. 
2. 
Remove the protective strip from one side of the tape. 
Press firmly into the designated area on the back of the 
mounting bracket. 
3. 
Remove the protective strip from the other side of the 
tape, and position the outdoor temperature/humidity 
sensor in the desired location. 
 
C. 
MOUNTING USING THE BRACKET AS A STAND 
The mounting bracket can be used as a stand by simply attaching 
the bracket to the bottom of the temperature/humidity sensor.  
Once snapped in place the sensor can then be placed on a shelf, 
table or other surface where the temperature and humidity 
measurements are desired. 
 
III.  MAINTENANCE AND CARE 
1. 
Extreme temperatures, vibrations, and shock should be avoided to 
prevent damage to the units 
2. 
Clean displays and units with a soft, damp cloth. Do not use solvents 
or scouring agents, they may mark the displays and casings 
3. 
Do not submerge in water. 
4. 
Do not subject the units to unnecessary heat or cold by placing them in 
the oven or freezer. 
5. 
Opening the casings invalidates the warranty. Do not try to repair the 
unit. Contact La Crosse Technology for repairs. 
 
IV. SPECIFICATIONS 
 
Temperature measuring 
range 
-21.8ºF to 157.8ºF with 0.2ºF 
resolution 
(-29.9°C to 69.9°C) 
Relative Humidity 
measuring range 
1% to 99% with 1% 
resolution) 
Transmission interval 
Every 10 seconds in first 3 
minutes  
Every 1 minute thereafter 
Transmission frequency 
433.92 MHz 
Power source 
2 x 1.5V AA Battery 
Alkaline recommended 
Dimensions (H x W x D) 
6.3” x 2.95” x 2.2” 
(160 x 75 x 55mm) 
 
 
 
downloadlike
ArtboardArtboardArtboard
Report Bug