Honeywell N431X User Manual

3 - 17

If you want to set your own length for the duration of the delay 

after activa-

tion, scan the After Activation bar code below, then set the time-out by 
scanning digits (0-65535 seconds) from the 

, then 

.  Default = 0 seconds.

When turned off, the bar code data will be output to the host as the engine 
decodes it.  When turned on, all output data must conform to an edited 
sequence or the engine will not transmit the output data to the host device.  
See 

on page 3-21 for further information.

This programming selection allows you to program the engine to output 
data (when scanning more than one symbol) in whatever order your appli-
cation requires, regardless of the order in which the bar codes are 
scanned.  Reading the 

Default Sequence symbol programs the engine to 

the following Universal values.  These are the defaults.  Be certain you 
want to delete or clear all formats before you read the 

Default Sequence 

symbol.

Note: If CodeGate is enabled, you must hold the external trigger down 

while reading each bar code in a sequence.

Note: To make Output Sequence Editor selections, you’ll need to know the 

code I.D., code length, and character match(es) your application 
requires.  Use the Alphanumeric symbols on the 

to read these options.

1. Scan the 

Enter Sequence symbol (see 

2. Code I.D.

want to apply the output sequence format.  Locate the Hex value for that 
symbology and scan the 2 digit hex value from the 

(inside back cover).

3. Length

Specify what length (up to 9999 characters) of data output will be 
acceptable for this symbology.  Scan the four digit data length from the 

.  (Note:  50 characters is entered as 0050.  9999 is