Honeywell N431X User Manual

3 - 20

You may wish to set the maximum time between bar code scans in an out-
put sequence.  If that maximum time is not met, the output sequence oper-
ation is terminated.  Set the length (in milliseconds) for a timeout by 
scanning the following bar code, then setting the timeout (from 1-65535 
milliseconds) by scanning digits from the 

.  

Default = 5000 msec.

By default, the engine beeps when a sequence match is found.  If you want 
the engine to remain silent, scan the following Sequence Match Beeper 
Off bar code.  

Default = Sequence Match Beeper On. 

If an output sequence operation is terminated before all your output 
sequence criteria are met, the bar code data acquired to that point is a 
“partial sequence.”   

Scan Discard Partial Sequence to discard partial sequences  when the 
output sequence operation is terminated before completion.