Delta 31-140 User Manual

RECOMMENDED MAINTENANCE

NOTE: Disconnect machine from power source before

performing any maintenance.

LUBRICATION

All bearings are sealed and permanently lubricated. No

further lubrication is needed.

ROUTINE INSPECTION

It is recommended that you periodically inspect your

spindle sander as a precautionary action. During this

time, check for the following:

• Inspect all hardware, fittings and fasteners that may

have loosened due to vibration and re-tighten as

needed.

• Check for dust and/or wood particles that may have

accumulated on or in the machine. Check all dust

collection fittings – re-tighten as needed.

• Inspect the ON/OFF SWITCH for damage before each

use. Periodically inspect the power cord and plug for

damage. If necessary replace the power cord and the

plug at the first signs of visible damage.

REPLACING THE SANDING DISC

M a k e c e r t a i n m a c h i n e i s

disconnected from power source.

• To remove sanding disc (A), simply peel old abrasive

disc from machine as shown.

• To install a new abrasive disc, make sure the disc plate

(B) is clean, dry, and free from any oil, grease, or old

adhesive.

• Peel back half the adhesive backing from the new disc

and slide between the table and disc plate so that the

half without the backing is aligned with the top half of

the disc plate.

• Press top half of sanding disc onto top half of disc

plate.

• Manually rotate disc plate one-half turn, remove

remainder of adhesive backing and firmly press sanding

disc onto disc plate.

Make certain the sanding disc is

securely in position before connecting

machine to a power source.

ACCESSORIES

A complete line of accessories is available from your DELTA

Supplier, DELTA

Factory Service Centers, and DELTA

Authorized Service Centers. Please visit our Web Site www.DeltaMachinery.

com for an online catalog or for the name or your nearest supplier.

Since accessories other than those offered by DELTA

have not been tested with this product,

use of such accessories could be hazardous. For safest operation, only DELTA

recommended

accessories should be used with this product.

Five Year Limited New Product Warranty

DELTA

will repair or replace, at its expense and at its option, any new DELTA

machine, machine part, or machine accessory which in normal

use has proven to be defective in workmanship or material, provided that the customer returns the product prepaid to a DELTA

factory service

center or authorized service station with proof of purchase of the product within five years and provides DELTA

with reasonable opportunity

to verify the alleged defect by inspection. For all refurbished DELTA

product, the warranty period is 180 days. DELTA

will not be responsible

for any asserted defect which has resulted from normal wear, misuse, abuse or repair or alteration made or specifically authorized by anyone

other than an authorized DELTA

service facility or representative. Under no circumstances will DELTA

be liable for incidental or consequential

damages resulting from defective products. Some states do not allow the exclusion or limitation of incidental or consequential damages, so

the above limitation or exclusion may not apply to you. This warranty is DELTA

’s sole warranty and sets forth the customer’s exclusive remedy,

with respect to defective products; all other warranties, express or implied, whether of merchantability, fitness for purpose, or otherwise, are

expressly disclaimed by DELTA

. For further detail of warranty coverage and warranty repair information, visit www.DeltaMachinery.com or call

1-800-223-7278. This warranty gives you specific legal rights and you may have other rights which vary in certain states or provinces.

WARRANTY

To register your tool for warranty service visit our website at www.DeltaMachinery.com.

LATIN AMERICA: This warranty does not apply to products sold in Latin America. For products sold in Latin America, see country

specific warranty information contained in the packaging, call the local company or see website for warranty information.