Grizzly H7777 Leaflet

Introduction

The outside blades of this 30 tooth dado set fea-
ture five sets of teeth. Each of these sets consist
of five angled teeth and a flat tooth. The angled
teeth shown in

Figure 2 cut the wood fibers

cleanly to prevent splintering and chipping at the
edge of the dado and the flat teeth cut the flat bot-
tom of the dado. Cutting a dado requires at least a
1½ HP table saw. Do not use this set in a portable
table saw, a miter saw, or a circular saw.

Set-Up

To install dado blades, do these steps:

1. UNPLUG THE TABLE SAW!

2. Remove the blade guard and anti-kickback

devices, the table insert, the arbor nut and
arbor flange, and the table saw blade.

MODEL H7777

8" STACK DADO SET

INSTRUCTION SHEET

Read and understand your table saw manual, set up your table saw according to the manual,

then use your table saw enough to be familiar with it before attempting dado cuts. Making dado

cuts is one of the more difficult operations that can be performed on a table saw. The size of the

cut increases the chances of kickback. Kickback happens when the workpiece is thrown towards

the operator at a high rate of speed. Until you have a clear understanding of kickback and how

it occurs, DO NOT use this dado set! We strongly recommend that you read books, trade maga-

zines, or get formal training before using this dado set. Failure to follow these warnings could

result in serious personal injury. Regardless of the content in this instruction sheet, Grizzly

Industrial will not be held liable for accidents caused by lack of training.

Figure 1. Inventory.

Inventory

(Figure 1)

Qty

Right Outside Blade .......................................... 1
Left Outside Blade ............................................. 1

⁄

" Chip Cutters ................................................. 4

⁄

" Chip Cutter .................................................. 1

⁄

" Chip Cutter .................................................. 1

0.005" Shims ..................................................... 2
0.010" Shims ..................................................... 2
0.015" Shims ..................................................... 2
0.020" Shims ..................................................... 2

WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE

OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.

#EW7524 PRINTED IN CHINA