Grizzly G0444 User Manual
G0444/G0444Z 10" Table Saw
-43-
3.
Tighten down one trunnion bolt a small
amount and then move on to each of the oth-
ers, tightening each down the same amount.
amount and then move on to each of the oth-
ers, tightening each down the same amount.
4.
Continue to rotate through the bolts, tighten-
ing them a little each time until they are all
secure.
ing them a little each time until they are all
secure.
5.
Flip the saw rightside up and repeat
steps 2-
6
on
page 41
.
6.
Once the miter slot is adjusted parallel to the
blade, recheck all measurements and be
sure the table mounting bolts are secure.
blade, recheck all measurements and be
sure the table mounting bolts are secure.
7.
Re-attach the blade guard and the fence.
8.
Verify that the blade guard is correctly
aligned with the blade.
aligned with the blade.
Figure 57.
45° blade parallelism measurement.
#1
#3
#2
Figure 56.
45° blade parallelism measurement.
#1
45˚ Bevel
45˚ Bevel
#3
#4
#4
#2
If the trunnion assembly is loosened in the
future, make note of the shim locations and
re-assemble accordingly.
re-assemble accordingly.
NOTICE
!
!
Front
Front
A
B