Delta 20-400 User Manual

9

•  Place top surface (A) upside down on a level surface. 

Attach the four legs (B) to the top using M6 X 16 

carriage bolts, M6 flat washers, and M6 hex nuts.

•  Attach bottom rail supports (C) using M6 X 16 

carriage bolts, M6 flat washers, and M6 hex nuts.

•  Place rubber feet (D) on bottom of legs. Turn 

assembled stand upright. 

•  Locate the four mounting holes (A) in the upper 

trunnion and attach the upper trunnion to the 

underside of the table using four M8 X 20 hex bolts, 

M6 lock washers, and M6 flat washers

•  Position the table assembly so that the upper 

trunnion fits into the lower trunnion and the trunion 

feed bolt (B) extends through the slot in the lower 

trunnion. 

NOTE:  The table tilt indicator (C) on the top trunnion 

should align with table tilt scale (D) on the bottom 

trunnion. 

•  Secure trunnion feed bolt using an 8MM flat washer 

and black table tilt locking wing nut (E). 

This step requires two adults. The 

DELTA

®

 14" Steel Frame Band Saw is 

heavy, be careful when lifting and 

handling it! Failure to comply may cause serious injury 

and/or damage to the machine and/or property!
Carefully lift the saw onto the assembled stand and 

align the four holes in base of the saw with the holes in 

the top of the stand. Secure saw to the stand using four 

M8 X 20 hex head bolts with M8 flat washer, M8 lock 

washer and M8 hex nut.