Wagner SprayTech 9195 User Manual

 

3

English

Can cause severe injury or property damage.

 

•  Read all instructions and safety precautions before operating 

equipment.

 

•  Follow all appropriate local, state, and national codes governing 

ventilation, fire prevention, and operation. 

 

•  The United States Government Safety Standards have been 

adopted under the Occupational Safety and Health Act 

(OSHA).  These standards, particularly part 1910 of the General 

Standards and part 1926 of the Construction Standards should 

be consulted.

 

•  Use only manufacturer authorized parts.  User assumes all 

risks and liabilities when using parts that do not meet the 

minimum specifications and safety requirements of the pump 

manufacturer.

 

•  Before each use, check all  hoses for cuts, leaks, abrasion or 

bulging of cover.  Check for damage or movement of couplings. 

Immediately replace the hose if any of these conditions exist.  

Never repair a paint hose. Replace it with another grounded 

high-pressure hose.

 

•  All hoses and fittings must be secured before operating spray 

pump. Unsecured parts can eject at great force or leak a high 

pressure fluid stream causing severe injury.

 

•  All hoses, swivels, guns, and accessories must be pressure 

rated at or above 3000 PSI/207 BAR.

 

•  Do not spray outdoors on windy days.

 

•  Wear clothing to keep paint off skin and hair.

 

•  Do not operate or spray near children.  Keep children away from 

the equipment at all times.

 

•  Do not overreach or stand on an unstable support.  Keep 

effective footing and balance at all times.

 

•  Stay alert and watch what you are doing.

 

•  Do not operate the unit when fatigued or under the influence of 

drugs or alcohol.

nOTICE - Use only a 3-wire extension cord that has a 3-blade 

grounding plug and a 3-slot receptacle that will accept the plug on the 

product.  Make sure your extension cord is in good condition.  When 

using an extension cord, be sure to use one heavy enough to carry the 

current your product will draw.  An undersized cord will cause a drop 

in line voltage resulting in loss of power and overheating.  A 14 or 12 

gauge cord is recommended (see chart below).  If an extension cord 

is to be used outdoors, it must be marked with the suffix W-A after the 

cord type designation.  For example, a designation of SJTW-A would 

indicate that the cord would be appropriate for outdoor use.

12

200 feet

14

100 feet

  •  Always disconnect the motor from the power supply before 

working on the equipment.  

This product must be grounded. In the event of an electrical short 

circuit, grounding reduces the risk of electric shock by providing an 

escape wire for the electric current. This product is equipped with a 

cord having a grounding wire with an appropriate grounding plug. 

The plug must be plugged into an outlet that is properly installed and 

grounded in accordance with all local codes and ordinances.

If repair or replacement of the cord or plug is necessary, do not connect 

the green grounding wire to either flat blade terminal. The wire with 

insulation having a green outer surface with or without yellow stripes is 

the grounding wire and must be connected to the grounding pin.

Check with a qualified electrician or serviceman if the grounding 

instructions are not completely understood, or if you are in doubt 

as to whether the product is properly grounded.  Do not modify the 

plug provided.  If the plug will not fit the outlet, have the proper outlet 

installed by a qualified electrician.

This product is for use on a nominal 120 volt circuit and has a 

grounding plug that looks like the plug illustrated below. Make sure that 

the product is connected to an outlet having the same configuration as 

the plug.  no adapter should be used with this product.

Grounded Outlet

Grounding Pin 

Cover for grounded outlet box