Wagner SprayTech 9185G User Manual

 

23 

Cause

Solution

1.

The spray tip was assembled incorrectly

Check tip assembly and assemble properly 

see page 19, steps 6-7

2.

Gun seal is worn

Replace the seal**

Cause

Solution

1.

The spray tip plugged

2.

The spray gun filter is clogged

Refer to Clean the Spray Gun Filter 

see page 13. Keep extra filters on hand

3.

The spray tip is in wrong position

Rotate spray tip to one of the spraying positions 

see page 12, step 5

4.

PRIME/SPRAY knob not set on SPRAY

Turn PRIME/SPRAY knob to SPRAY 

see page 9 Getting Material to Flow

Cause

Solution

1.

Pressure too low

Increase the pressure

2.

The spray tip is plugged

3.

The inlet filter is clogged

Refer to Clean the Inlet Filter 

4.

The spray gun filter is clogged

Refer to Clean the Spray Gun Filter 

see page 13.  Keep extra filters on hand

5.

The spray tip is worn

Replace the spray tip

6.

The material is too thick

Thin material using appropriate thinning solution

7.

Pressure loss

Refer to Causes and Solutions for Problem C

Cause

Solution

1.

High pressure has locked the spray tip in place

The only daily maintenance necessary is thorough cleaning.  Follow the cleaning procedures in this manual.

** Additional parts are available for this procedure. Refer to the Parts List (page 74) section of this manual for a list of the parts and their part numbers

Some pump parts eventually wear out from use and must be replaced. The following is a list of 

available repair kits. Pump performance is the only reliable indicator of when to replace wear parts. 

Refer to the Troubleshooting section for more information on when to use these kits

0512178A 

Fluid Section Seal Kit

0501014  

Saddle seat/seal kit