Woodstock W1747 User Manual
-8-
W1747 20" Planer
SA
FE
T
Y
Additional Safety Instructions for Planers
USE this and other machinery with caution
and respect. Always consider safety first,
as it applies to your individual working
conditions. No list of safety guidelines can
be complete—every shop environment is
different. Failure to follow guidelines could
result in serious personal injury, damage
to equipment or poor work results.
READ and understand this
entire instruction manual
before using this machine.
Serious personal injury
may occur if safety and
operational information is
not understood and fol-
lowed. DO NOT risk your
safety by not reading!
1. INFEED CLEARANCE SAFETY: The infeed roller is designed to pull material into the cutterhead.
Always keep hands, clothing, and long hair away from the infeed roller during operation to pre-
vent serious injury.
2. BODY POSITION WHILE OPERATING: The workpiece may kick out during operation. To avoid get-
ting hit, stand to the side of the planer during the entire operation.
3. PLANING CORRECT MATERIAL: Planing materials not designed for this planer creates a hazard for
yourself and the machine. Only plane natural wood stock with this planer. DO NOT plane MDF,
plywood, laminates, or other synthetic or man-made products.
4. GRAIN DIRECTION: Planing across the grain is hard on the planer and may cause the workpiece to
kick out. Always plane in the same direction or at a slight angle with the wood grain.
5. CLEAN STOCK: Planing stock with nails, staples, or loose knots MAY cause debris to kick out at
the operator and WILL damage your cutters when they contact the cutterhead. Always thoroughly
inspect and prepare stock to avoid these hazards.
6. MACHINE LIMITATIONS: The planer may kick out a workpiece at you or you can damage it if it is
pushed beyond these limits:
• Maximum Depth of Cut:
1
/
8
"
• Minimum Board Length: 7"
• Minimum Board Thickness:
1
/
4
"
• Maximum # of Boards at One Time: 1
7. LOOKING INSIDE PLANER: Wood chips fly around inside the planer at a high rate of speed. DO
NOT look inside the planer or remove guards/covers during operation.
8. REMOVING JAMMED WORKPIECES: Attempting to remove jammed workpieces while the planer is
running may cause serious injury to the operator. Always stop the planer and disconnect power
before removing jams.
9. DULL/DAMAGED CUTTERS: The planer may kick out a workpiece at the operator or give poor fin-
ish results if it is operated with dull or damaged cutters.
10. UNPLUGGING DURING ADJUSTMENTS: When connected to power, the planer can be accidentally
turned
ON. Always disconnect power when servicing or adjusting the components of the planer.