Grizzly G0453 User Manual
-18-
g0453/g0454 (Mfg. since 3/08)
Lifting & Moving
Base unit
the Model G0453/G0454
is a heavy machine.
Serious personal injury
may occur if safe moving
methods are not used. to
be safe, get assistance
and use power equip-
ment to move the ship-
ping crate and remove the
machine from the crate.
the cabinet stand on the Model g0453/g0454
planer is equipped with four lifting bars that pull
out in order to lift and place the planer, as shown
in
planer is equipped with four lifting bars that pull
out in order to lift and place the planer, as shown
in
figure 7.
figure 7. lifting the planer with a forklift.
lifting
Bar
(1 of 4)
tip: When positioning the lift forks, place shop
rags or cardboard between the forks and the cabi-
net stand to avoid scratching the paint.
rags or cardboard between the forks and the cabi-
net stand to avoid scratching the paint.
Assembly
to assemble your planer:
1. install M8-1.25 x 20 set screws in the holes in
the bottom of the wings (see
figure 8).
figure 8. Front extension wing installed (Model
g0454 shown).
set screws
hex Bolts &
Flat Washers
2. Attach the table extension wings to the planer
table with the M8-1.25 x 30 hex bolts, 8mm
lock washers, and 8mm flat washers, as
shown in
lock washers, and 8mm flat washers, as
shown in
figure 8, but do not fully tighten the
bolts at this time.
3. using a straightedge as a guide and the
set screws for leveling control, position the
extension wings even with the table, then
fully tighten the hex bolts.
extension wings even with the table, then
fully tighten the hex bolts.
Note: Be aware that the bed rollers will give
you a false reading with your straightedge if
they are raised above the table. Move them
down or work around them when leveling the
extension wings.
you a false reading with your straightedge if
they are raised above the table. Move them
down or work around them when leveling the
extension wings.
assembly