Delta 22-790X User Manual

9

1.   Turn stand over on its side and attach four leveling feet 

(K) Fig. 5 to the four tapped holes in the bottom of the

legs (B). Be sure leveling feet jam nuts (L) are loose.

2.   Turn  machine  upright  and  rotate  leveling  feet  until 

machine is level.

3.   Tighten jam nuts.

If you desire, you can secure the stand to the floor. You can 

use the four holes (M) Fig. 6 for this purpose.

1.  Attach handwheel handle (N) Fig. 7 to handwheel (O).

Use 12 mm open end wrench on flats to tighten.

2.  Attach handwheel (O) to elevation shaft (P) Fig. 8 and

tighten  handwheel  set  screw  (Q)  FIg.  9  with  supplied

hex  wrench.  Be  sure  set  screw  engages  groove  (R)

Fig. 8 in elevation shaft.

 

NOTE: Be sure two head-locking knobs (one shown at

(S) Fig. 10) are loose before raising head assembly.

3.   Raise head assembly and remove shipping brace.