Beko DRCS 76 W User Manual

10 - EN

Make sure that you have an earthed 

power outlet socket rated at 13 amps 

(minimum).

If you use your dryer as built-in, 

the socket must be reachable after 

installation, or a separate switch (which 

can disconnect the two poles) must 

be used in the installation. Check for 

suitability.

For a permanent connection, a master 

switch with at least 3mm contact 

clearance and minumum 13 A rating 

must be used.

Before you insert the plug into the wall 

socket make sure that the voltage and 

the frequency shown in the rating label 

corresponds to your electricity supply. 

We recommend that this appliance be 

connected to the mains supply via a 

suitable switched and fused socket in a 

readily accessible position. 

Should the mains lead of the appliance 

become damaged or need replacing at 

any time, it must be replaced by a special 

purpose made mains lead which can only 

be obtained from a Authorised Service 

Agent. 

A

If the fitted moulded plug is not suitable 

for your socket, then the plug should be 

cut off and an appropriate plug fitted. 

The moulded plug on this appliance 

incorporates a 13A fuse. Should the fuse 

need to be replaced an ASTA approved 

BS1362 fuse of the same rating must 

be used. Do not forget to refit the fuse 

cover. In the event of losing the fuse 

cover, the plug must not be used until a 

replacement fuse cover has been fitted. 

Colour of the replacement fuse cover 

must be the same colour as that visible 

on the pin face of the plug. Fuse covers 

are available from any good electrical 

store.

In order to avoid hazards, damaged 

supply cord should be replaced by the 

manufacturer, its service agent or similarly 

qualified people.

This appliance can be installed under a 

worktop.

A

  Only authorised specialists are 

permitted to car ry out a built-under 

installation. Risk of electric shock!

A

As the colours of the wires in the 

mains lead of this appliance may not 

correspond with the coloured markings 

identifying the terminals on your plug, 

proceed as follows:

1 Connect the green - yellow or green 

(earth) wire to the terminal in the plug 

marked ‘E’ or with the symbol   or 

coloured green and yellow or green.

2 Connect the blue (neutral) wire to 

the terminal in the plug marked ‘N’ or 

coloured black.

3 Connect the brown (live) wire to 

the terminal in the plug marked ‘L’ or 

coloured red. 

With the alternative plugs a 13A fuse 

must be fitted either in the plug or 

adaptor or in the main fuse box. If in 

doubt contact a qualified electrician.

Do not stack washing machine on top 

of the tumble dryer. This would damage 

both appliances and guarantees would 

become void. It is also unsafe to stack 

an appliance on top of another without 

using a suitable and approved stacking 

kit obtained from the manufacturer of the 

appliances.

• A special stacking kit is required as an 

optional extra please contact customer 

service.

Green and yellow

or green

Blue or black

Brown or red