Beko DRCS 76 W User Manual

20 - EN

A

 

Never use solvents, cleaning 

agents or substances alike when 

cleaning as these might cause fire and 

explosion! 

The moisture in the damp laundry is taken 

from the laundry and condensed. Drain 

the water tank after each drying cycle or 

during drying when “Water tank” warning 

LED comes on.

A

 

Condensed water is not 

drinkable! 

C

 You can use the water in the water 

tank in your steam irons or air 

humidifiers.

A

 

Never take out the water tank 

when the programme is running!

Water tank may be located in two 

different places as indicated below, 

depending on the model of your machine.

Inside the drawer on the panel

- 

Inside the kick plate cover

- 

If you forget to drain the water tank, your 

machine will stop during the following 

drying cycles when the water tank is 

full and the “Water tank” warning LED 

will light on. If this is the case, press the 

“Start/Pause/Cancel” button to resume 

the drying cycle after draining the water 

tank.

In order to drain the water tank;

1  Carefully remove the water tank by 

opening the kick plate cover/pulling the 

drawer.

2  Drain the water by opening the water 

tank cover.

3  If there is lint accumulation in the water 

tank cover, clean it and press to close. 

4  Place the water tank into its seat. 

Lint and fibres released from the laundry 

to the air during the drying cycle are 

collected in the “Cover Filter”.

C

 

Such fibre and lint are generally 

formed during wearing and washing.

C

 

Always clean the filter after each 

Drying process.

C

 

You can clean the filter and filter 

area by vacuum cleaner.

For Filter cleaning;

1  Take out the cover

2  Remove the cover filter by pulling it up 

and open the filter.

3  Clean lint, fibre, and cotton raveling by 

hand or with a soft piece of cloth.

4  Close the filter and place it back into its 

seat.

There are humidity sensors in your 

machine that detect whether the laundry 

is dry or not.

For sensor cleaning;

1  Open the cover of your machine.

2  Allow the machine to cool off if drying 

has been carried out.

3  Wipe the metal sensors with a soft 

cloth, dampened with vinegar and dry 

them.

C

 Clean metal sensors 4 times a year.