Delta 46-455 User Manual

FACEPLATE

To reduce the risk of injury, tighten all

screws and levers securely when adjusting any part of

the lathe.

To reduce the risk of injury, when using the

included 3" (76 mm) faceplate (B) Fig. 2, do not mount

pieces larger than 6" (152 mm) in diameter and up to 6"

(152 mm) in length. For mounting larger pieces, be sure

to use an appropriately sized faceplate.

REMOVING FACEPLATE

To remove the faceplate, use the included 3 mm hex

wrench to unlock the set screws (L) at least two full turns.

Place knockout bar (H) Fig. 3 in hole (M) Fig. 2 and place

faceplate wrench (I) Fig. 3 on faceplate shoulder flats (as

shown in Fig. 3) and turn wrench to loosen faceplate.

Once loose, the faceplate (B) Fig. 2 can be unscrewed.

REPLACING FACEPLATE

FOR THE DELTA

MODEL 46-460 MIDI-

LATHE ONLY: To reduce the risk of injury, if turning

in reverse, be sure to tighten the set screws (L) Fig. 2

securely when replacing the faceplate.

To re-attach faceplate (B) Fig. 4, screw it back on to the

spindle nose (K) and tighten securely using the knockout

bar and wrench as shown in figure 3. Replace set screws

(L) Fig. 2 if removed. Tighten set screws securely.

Directions for mounting a workpiece to the faceplate can

be found in the section

Mounting the Workpiece under

MACHINE USE.

Fig. 3

Fig. 4

Fig. 2