Southbend SB1037 User Manual
-50-
For Machines Mfg. Since 7/09
EVS Toolroom Lathes
O P E R A T I O N
The chip drawer shown in Figure 99 catches
swarf and metal chips during the machining
process. It easily slides open to provide access to
swarf during cleanup.
swarf and metal chips during the machining
process. It easily slides open to provide access to
swarf during cleanup.
Also, the chip drawer contains a screen that
allows runoff cutting fluid to drain back into the
cutting fluid tank.
allows runoff cutting fluid to drain back into the
cutting fluid tank.
Chip Drawer
If pulled out quickly and more than half of the
way, the drawer could fall out and hit your
feet, causing serious injury. Therefore, open
the drawer slowly and avoid opening it more
than half of the way.
way, the drawer could fall out and hit your
feet, causing serious injury. Therefore, open
the drawer slowly and avoid opening it more
than half of the way.
Figure 99. Chip drawer.
Other Fractional TPI
Use position 1 on the thread dial for cutting the
TPI shown in Figure 97.
TPI shown in Figure 97.
Figure 97. Any number on dial is selected for other
fractional TPI.
Position
1 Only
1 Only
2¼,2¾,
3¼,3¾
3¼,3¾
2
7
⁄
8
TPI
Use any numbered or non-numbered line on the
thread dial to cut the TPI shown in Figure 98.
thread dial to cut the TPI shown in Figure 98.
Figure 98. Any number on the dial can be selected for
2
7
⁄
8
TPI.
2
7
⁄
8
Same as
Metric
Threads
Metric
Threads