Roland CX-24/12 User Manual
37
5 Performing a Self-Test
1
2
3
4
5
Performing a Self-Test
The CX-24/12 is equipped with a "self-test" function to conveniently allow you to check whether or not it is capable of operating
normally. If the CX-24/12 is not performing correctly, follow the steps below to perform a self-test.
A computer is not required in order to carry out the self-test.
normally. If the CX-24/12 is not performing correctly, follow the steps below to perform a self-test.
A computer is not required in order to carry out the self-test.
Hold down the [
] key on the panel while you turn
the power on.
When the display shows the screen at right, press the
[ENTER] key to start the operation check.
Operations is normal if the figure shown at right is
cut.
[ENTER] key to start the operation check.
Operations is normal if the figure shown at right is
cut.
material.
SELECT | ROLL
SETUP -> ENTER
CX-24
CX-12
" and install the blade
holder to the cutting carriage on CX-24/12.