Maxxsonics MLX-100 User Manual

MASTER OUT / SLAVE IN: The Master Out sends master signal to another MLX-100.
The Slave In receives a Master signal and all controls are bypassed on the unit.

BR-1 REMOTE CONTROL: Using an Rj45 cable, the BR-1 Bass Remote Module plugs
directly into the MLX-100 and allows you to adjust the Level from -20dB to 0 dB as well
as Normal and Bypass operations.
    NORMAL: BR-1 is fully adjustable from -20dB to 0dB.
    BYBASS: BR-1 is set to 0dB fixed regardless of where the dial is set.

LINE INPUT: Accepts unbalanced RCA inputs from 0.2 volts to 9 volts.

LINE OUTPUT: The unbalanced RCA outputs are Left and Right Full Range outputs.

BRIDGING OUTPUTS:  A+/- through E+/- provide signal output to up to 10 linked mono
block amplifiers. 

MASTER/ SLAVE MODE: Should be set in Master position when controlling amplifiers
and Slave position when it is being controlled by another MLX-100. 

LOW PASS FILTER: The Low Pass Filter is fully adjustable from 35Hz to 250Hz at
 24dB per Octave.

SYSTEM DIAGNOSTICS: The MLX-100 has built-in monitoring devices. The light
turns RED when the signal is Clipped and Green when it is 9 volts.

OUTPUT LEVEL: Fully adjustable signal output to amplifiers from 1 volt to 9 volts. 

TEST TONE: Selectable OFF/ON 65Hz Test Tone provides a constant tone for testing
and tuning the output level on the amplifiers.  

SUBSONIC FILTER: The Subsonic Filter is fully adjustable from 15Hz to 35Hz at 24dB
per Octave.

INPUT LEVEL: The Input Level (gain) control allows you to match the MLX-100 input
sensitivity to the Output Level of the source from 9 volts to 0.2 volts. 

PHASE: The Phase Shift is fully adjustable from 0 to 180 degrees.

PARAMETRIC BASS EQ:
   BOOST: The Bass Boost is fully adjustable from 0dB to 10dB.
   BANDWIDTH: The Bandwidth is fully adjustable from narrow to wide. 
   FREQUENCY: The Frequency is fully adjustable from 30Hz to 100Hz.