Grizzly H8148 User Manual
-10-
H8148/H8149/H8150 Heavy Duty Bench Ginders
Figure 2. Typical type 5-15 plug and receptacle.
Serious personal injury could occur if you
connect the machine to the power source
before you have completed the set up pro-
cess. DO NOT connect the machine to the
power source until instructed to do so.
110V Operation
Amperage Draw
The Model H8148/H8149/H8150 motor draws the
following amps under maximum load:
following amps under maximum load:
Motor Draw (H8148) ................................5 Amps
Motor Draw (H8149) ................................8 Amps
Motor Draw (H8150) .............................. 10 Amps
Motor Draw (H8149) ................................8 Amps
Motor Draw (H8150) .............................. 10 Amps
Circuit Recommendations
We recommend connecting your machine to a
dedicated and grounded circuit that is rated for
the amperage given below. Never replace a circuit
breaker on an existing circuit with one of higher
amperage without consulting a qualified electri-
cian to ensure compliance with wiring codes.
dedicated and grounded circuit that is rated for
the amperage given below. Never replace a circuit
breaker on an existing circuit with one of higher
amperage without consulting a qualified electri-
cian to ensure compliance with wiring codes.
If
you are unsure about the wiring codes in your
area or you plan to connect your machine to a
shared circuit, consult a qualified electrician.
110V Circuit (H8148/H8149/H8150) ......15 Amps
Plug/Receptacle Type
Included Plug Type ........................... NEMA 5-15
This machine must have a ground prong in
the plug to help ensure that it is grounded.
DO NOT remove ground prong from plug
to fit into a two-pronged outlet! If the plug
will not fit the outlet, have the proper outlet
installed by a qualified electrician.
Extension Cords
We do not recommend the use of extension cords,
but if you find it absolutely necessary:
but if you find it absolutely necessary:
•
Use at least a 14 gauge cord that does not
exceed 50 feet in length!
exceed 50 feet in length!
•
The extension cord must also contain a
ground wire and plug pin.
ground wire and plug pin.
•
A qualified electrician MUST size cords over
50 feet long to prevent motor damage.
50 feet long to prevent motor damage.
Electrocution or fire could
result if this machine is
not grounded correctly or
if your electrical configu-
ration does not comply
with local and state codes.
Ensure compliance by
checking with a qualified
electrician!
SECTION 2: CIRCUIT REQUIREMENTS