Delta 23-199 User Manual

9

1.  Fit two M5 x 10mm hex screws with an M5 lock 

washer and flat washer. Use assembled hex screws 

and washers to secure spark shield (A) to the wheel 

guard. Spark shield should be approximately 1/8"  

from the grinding wheel.

2.  Repeat previous step for second spark shield. 
3.  Use one M5 x 12mm carriage bolt, inserted through 

the outermost hole in the spark shield, to attach the 

grinding shield (B). Secure using one M5 flat washer 

and a threaded thumb knob.

4.  Repeat previous step for second grinding shield.

Remove any protective materials and coatings from all of the parts and the tool. The protective coatings can be 

removed by spraying WD-40 on them and wiping it off with a soft cloth. This may need redone several times before 

all of the protective coatings are removed completely. 

If any parts are missing, do not attempt to plug in the power cord and turn “ON"  the machine. The 

machine should only be turned “ON"  after all the parts have been obtained and installed correctly.

1.  Attach tool rest support (A) to the inner face of the 

wheel guard using two M8 x 10mm hex screws 

fitted with M8 flat washers. Finger tighten only. 

NOTE: The serrated boss on the tool rest support 

should be facing in toward the center of the tool. 

2.  Attach tool rest (B) to the tool rest support using 

one M5 x 18mm thumb screw.

3.  Adjust the position of the tool rest support so that 

the tool rest is approximately 1/8"  from the grinding 

wheel (C).

4.  Tighten the two M8 x 10mm hex screws on the tool 

rest support using the tool wrench provided. 

5.  Repeat above steps for second tool rest.