Black & Decker LST220 User Manual

3. If the battery pack does not charge properly:

a. Check current at receptacle by plugging in a lamp or other

appliance

b. Check to see if receptacle is connected to a light switch

which turns power off when you turn out the lights.

c. Move charger and battery pack to a location where the

surrounding air temperature is approximately 60°F - 80°F

(16° - 27°C).

d. If charging problems persist, take the tool, battery pack and

charger to your local service center.

4. The battery pack should be recharged when it fails to produce

sufficient power on jobs which were easily done previously. DO

NOT CONTINUE to use under these conditions. Follow the charging

procedure. You may also charge a partially used pack whenever

you desire with no adverse affect on the battery pack.

5. Foreign materials of a conductive nature such as, but not limited

to, steel wool, aluminum foil, or any buildup of metallic particles

should be kept away from charger cavities. Always unplug the

charger from the power supply when there is no battery pack in the

cavity. Unplug charger before attempting to clean.

6. Do not freeze or immerse charger in water or any other liquid.

Shock hazard. Do not allow any liquid to get

inside charger. Never attempt to open the battery pack for any 

tO iNStAll BAttERY PACK:

Insert battery pack into tool until fully

seated and an audible click is heard

(figure 2).

PACK: Depress the battery release

button in the back of the battery pack 

and

pull battery pack out of tool.