Zenoah EXZ2401S User Manual

■ MOUNTING ENGINE (SE1)
1. Push the drive shaft housing toward the clutch

housing and rotate it by hand to check that the
driveshaft is engaged with the gears.

2. Insert the drive shaft housing into the clutch housing

until it bottoms, and align the positioning holes on
the clutch housing and the shaft tube and install the
screw. When difficult to engage, twist the engine
slightly.

3. Fasten the clamp securely with two screws.

Tighten the screws gradually by turns.

■ CONNECTING THROTTLE WIRE
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to the joint on

the top of the carburetor. (SE2)

■ CONNECTING SWITCH WIRES (SE3)
• Connect the switch wires between the engine and

the main unit. Pair the wires of the same color. 

• Bind switch wires to throttle wire with tie band.

■ INSTALLING HANDLE

(EX2-BC, EX-LRT only) (SE4)
• Install the handle to the shaft tube and clamp it at a

location that is comfortable to you. 

(EX-PS only) (SE5)
• Insert the grip to the shaft tube.
• Fasten the clamps with screws.

(EX-HE only) (SE6)
• Install the J-shaped handle to the shaft tube and

clamp at a position best for your job. 

■ JOINT ATTACHMENT (SE7)
• Insert the attachment to the main shaft. 
• Tighten the knob bolt securely.