Zenoah EXZ2401S User Manual

tighten the blade mounting bolt. (SE3)

4. Split the bracket and install the wheel assembly to

the shaft tube and clamp at a position best for your
job. (SE4)

■ SWEEPER ASSEMBLY (SE1)
1. Push one of the drum axles onto either of the two

gearcase output shafts. If necessary, rotate the drum
axle until the clevis pin hole in the axle aligns with
the matching hole in the gearcase output shaft. 

2. Use a clevis pin and hitch pin to secure the drum

axel to the shaft. 

3. Slide the recessed end of a sweeper drum assembly

over the assembled axle, and then push the drum
down the axel until it bottoms at the clevis pin. 

The two drum assemblies are identical, but each drum
must be installed with its recessed end facing toward
the gearcase. 

4. Use a cotter pin to secure the drum assembly on the

axle (see inset) . The cotter pin is designed to fit
tightly against the outboard end of the drum, so you
may need to compress the drum face slightly during
installation. 

5. Repeat Steps 1-4 to install the remaining axle and

drum assembly.