Zenoah EXZ2401S User Manual

■ REFILLING TRIMMING LINE (MA1)
1. For replacement line, use a diameter of .095in

(2.4mm). The spool is capable for a line upto 20ft
(6m) on the 4” head. Avoid using a larger line as it
may cut down the trimming performance. 

2. Pinch the slotted area on the both sides of the spool

housing to unhook the bottom cap.

3. Take out the spool and pull off the old line. Fold new

line so that one half line is 4.7in.(12cm) shorter than
another half. And then, hook bended end in the slot
of the spool.

4. Wind up the line in the correct direction as indicated

on the spool.

5. Hook each end of the line in the slot on the edge of

the spool, and then put the ends through the eyelets
on the housing. Make sure that the spring and the
washers are in place.

6. While holding the spool against the housing, pull the

line ends to release them from the slot.

7. Line up the slot on the bottom cap with the hook on

the housing, press the cap against the housing until
it clicks.

■ GEAR CASE (MA2)
• The reduction gears are lubricated by multipurpose,

lithium-based grease in the gear case. Supply new
grease every 25 hours of use or more often
depending on the job condition. 

• Remove the side bolt in gearcase opposite of grease

nipple before installing new grease to arrange for old
grease to exit.