Motorola MF-P01 User Manual
PORTASTUDIO MF-P01
7
1
DC IN 12 V connector and POWER switch
Use this jack to connect the PS-P2 AC adaptor which comes with your MF-P01.
When connecting the power, make sure the power switch is off (slide it to the right, as you look from the
back).
Slide the switch to the left (looking from the back) to turn on the power to the MF-P01.
When connecting the power, make sure the power switch is off (slide it to the right, as you look from the
back).
Slide the switch to the left (looking from the back) to turn on the power to the MF-P01.
WARNING
DO NOT use any adaptor with the MF-P01 except the PS-P2 adaptor which comes with the MF-P01.
NOTE
The equipment draws nominal non-operating power from the AC outlet with its POWER switch in the off
position.
position.
2
MIC/LINE jack
Use this 1/4" phone jack to connect an audio source (instrument or microphone) to the MF-P01.
The source signal is sent to a recording track, as well as fed from the LINE OUT (L, R) and PHONES jacks.
The source signal is sent to a recording track, as well as fed from the LINE OUT (L, R) and PHONES jacks.
3
PHONES jack
Use this 1/4" jack to connect a pair of stereo headphones to monitor tape playback or/and MIC/LINE input
signals.
signals.
CAUTION
• When using the LINE OUT jacks, to obtain better audio performance, unplug headphones.
WARNING
• Do not use headphones equipped with a mono jack. This will cause damage to the MF-P01’s headphone
amplifiers.
4
LINE OUT jacks
Use these RCA (pin or phono) jacks to connect your MF-P01 to the amplifier or master recorder.
Tape playback or/and MIC/LINE input signals are output from these jacks.
Tape playback or/and MIC/LINE input signals are output from these jacks.
Parts of the MF-P01