Tascam D00871320A User Manual
Punching
32
TASCAM DP-01 Owner’s Manual
Advanc
ed techn
iques
Punching
As mentioned in “Punch recording” on page 25, the DP-01 provides
two manual ways of changing between playback and recording
modes: using the
two manual ways of changing between playback and recording
modes: using the
PLAY
and
RECORD
keys, and using the foot switch.
There is also an automated punch mode, described here.
Rehearsal
The
RHSL
key indi-
cates you are in
"rehearsal" mode, as long as
AUTO
PUNCH
is not lit. Your rehearsal
take(s) is not actually recorded.
The autopunch mode allows you to rehearse your playing before actually
making a recording.
making a recording.
1
First, set the IN and OUT points (“IN and OUT marks” on page 29)
so that they correspond to the points where you want recording to
start, and where you want it to finish.
so that they correspond to the points where you want recording to
start, and where you want it to finish.
If you’re replacing a
mistake, make sure
mistake, make sure
that the sound you are recording
matches the sound you're replacing
(same effect settings, etc.).
matches the sound you're replacing
(same effect settings, etc.).
2
Assign an input or inputs to a track or tracks (“Assigning inputs” on
page 23), and arm those track(s) for recording (press the track’s
page 23), and arm those track(s) for recording (press the track’s
REC
key so that it flashes).
3
Press the
AUTO PUNCH
key so that it lights.
4
Press the
RHSL
(rehearsal) key so that it lights.
5
Press the
PLAY
key.
Playback starts from before the IN point (the
PLAY
indicator is lit).
If the IN and OUT
points are not
points are not
where they should be for your
punch recording operation, you can
turn off
punch recording operation, you can
turn off
AUTO PUNCH
and edit
their position (See “IN and OUT
marks” on page 29).
marks” on page 29).
At the IN point, the playback of the armed track(s) stops. The
RECORD indicator starts to flash, indicating this the point where
recording would start were you actually punching in.
RECORD indicator starts to flash, indicating this the point where
recording would start were you actually punching in.
At the OUT point, the signal you hear returns to what you recorded
earlier. The
earlier. The
RECORD
indicator stops flashing.
When playback reaches the post-roll point, it stops. When you do your
next rehearsal or punch, playback will start from the pre-roll point.
next rehearsal or punch, playback will start from the pre-roll point.
You can rehearse
by looping bet-
by looping bet-
ween the pre-roll and post-roll
points using the
points using the
REPEAT
key.
6
Repeat the rehearsal as many times as you need until you are happy
with your performance.
with your performance.
Post-roll
IN point
OUT point
What you hear
Playback from previously
recorded track starts at
pre-roll position, up to IN
recorded track starts at
pre-roll position, up to IN
Recorded signals are cut
flashes in rehearsal,
lights when recording)
lights when recording)
Return to track playback
out) and playback stops
at post-roll point
at post-roll point
You can always hear the input signal
Pre-roll
point (PLAY indicator lights).
(RECORD indicator (RECORD indicator goes
DP-01_OM_E.book 32 ページ ２００５年６月１３日 月曜日 午後７時１４分