Korg SQ-10 User Manual

 
 

 
 
 
[ 

  numbers refer to the front panel illustration. See 7 FoldOut ]  

 
 
 

Use this clock when you want to run through the steps automatically. Clockspeed is controlled by voltage, so you 
can use Channel-C to vary the step spacing or any other source to control the overall speed. 

 

   Clock speed:  

Use this knob to adjust the basic speed of the sequence when you advance the steps  

 

automatically.  A flashing LED indicates the basic click rate (in both the "run" and "stop" state.) 

 
 
 

Linear In ( 0  ~  +5V ):  Use this INPUT jack when you want linear variation of the speed set by the Clock 
speed knob. 

 
 

x 2-volt ( 0  ~  +5V ):   Use this INPUT jack when you want to speed up the clock speed.  A 1V input doubles 
the speed; 2V gives 4 times the speed, 3V gives 8 times  the speed so forth.  In other words, the clock speed 
doubles for each 1V increase.   This means that the time for each step is halved (1/2, 1/4, 1/8, etc.) for  each 1V 
increase in input. 

 
 

/ 2-volt ( 0  ~  +5V ):  This INPUT jack is used when you want to slow down the clock speed by 1/2 for each 
1V in the input.  This means that the step time will double for each 1V increase. 

 
 
 

Start/Stop Button:   Use this button to start and stop automatic step control via the clock. 

Step Button:  Press for manual step advance. The sequence advances 1-step each time you press the button. 

 
 
 

 
 

Use this INPUT jack when you want to use an external trigger or foot switch to advance one step at a time. 

 
 
 

Use this INPUT jack when you want to start or stop a clock-controlled automatic sequence by means of an 
external trigger or foot switch. 

 
 
 

5