Panasonic 35 User Manual
Operation modes
15
3) Continuous irradiation
Irradiation using the EMISSION switch of the controller
The
The
The
The
displayed
displayed
displayed
displayed
values
values
values
values
apply
apply
apply
apply
to
to
to
to
the
the
the
the
flashing
flashing
flashing
flashing
channel.
channel.
channel.
channel.
(1) Starting irradiation 1. Select the channel/s for irradiation.
2. Press the EMISSION switch
(Irradiation will start on all channels indicated by red lights. The
EMISSION switch glows red during irradiation.)
(2) Stopping irradiation 3. While irradiation is in progress press the EMISSION switch
again. (Irradiation will stop on all channels.)
4) Irradiation using an external start signal
Irradiation can be started externally using the INPUT terminals on the rear of the controller—either
“START ALL” or “START1-4.”
(1) Starting irradiation 1. Turn on the START signal.
(Irradiation is activated under the conditions summarized below.)
○･･･Irradiation starts when the start signal is switched from OFF
to ON. (Duration is per timer setting.)
●･･･Irradiation starts when the start signal is switched from
OFF to ON, and stops with an OFF signal (at “Con”
setting)
Case of START ALL: When the START ALL signal is turned ON
irradiation starts simultaneously on all
selected channels.
Case of START1-4: When the signal of a START No. terminal is
switched ON irradiation starts on the
corresponding CH No.
(2) Stopping irradiation 2. Switch the STOP signal to ON.
(Irradiation can also be stopped by pressing the EMISSION switch.)
INPUT terminal
Start signal
setting
START ALL
START1-4
PULSE
○
○
STATUS
●
●