Panasonic EY6506 User Manual

- 4 - 

  Some dust created by power sanding, 

sawing, grinding, drilling, and other 

construction activities contains chemi-

cals known to the State of California 

to cause cancer, birth defects or other 

reproductive harm. Some examples 

of these chemicals are:

 Lead from lead-based paints

 Crystalline silica from bricks and 

cement and other masonry products

 Arsenic and chromium from chemi-

cally-treated lumber.

  To reduce your exposure to these 

chemicals: work in a well ventilated 

area, and work with approved safety 

equipment, such as dust masks that 

are specially designed to filter out 

microscopic particles.

 1) 

  - This manual contains important 

safety and operating instructions for 

battery charger EY0110.

 2) Before using battery charger, read all 

instructions and cautionary markings on 

(1) battery charger, (2) battery pack.

 3) 

 - To reduce the risk

of injury, charge only Battery Pack as 

shown below. 

   EY9065, EY9066, EY9168, EY9080,

EY9086, EY9180, EY9182, EY9001,

EY9006, EY9101, EY9106, EY9200,

EY9201, EY9136, EY9230, EY9231,

EY9251, EY9117, EY9210

   Other types of batteries may burst 

causing personal injury and damage.

 4) Do not expose charger to rain or snow.
 5) To reduce risk of damaging the electric 

plug and cord, pull by plug rather than 

cord when disconnecting charger.

 6) Make sure cord is located so that it will 

not be stepped on, tripped over, or oth-

erwise subjected to damage or stress.

 7) An extension cord should not be used 

unless absolutely necessary.

Use of improper extension cord could 

result in a risk of fire and electric shock. 

If extension cord must be used, make 

sure that:

a. pins on plug of extension cord are 

the same number, size and shape as 

those of plug on charger.

b. extension cord is properly wired and 

in good electrical condition.

c. wire size is large enough for ampere 

rating of charger as specified below

RECOMMENDED MINIMUM AWG SIZE OF

EXTENSION CORDS FOR

BATTERY CHARGERS

AC Input Rating.

Amperes

AWG Size of Cord

Equal to or 
greater than

But less 
than

Length of Cord, Feet

25 50 100 150

0

2

18 18 18 16

 8) Do not operate charger with damaged 

cord or plug-replace them immediately.

 9) Do not operate charger if it has re-

ceived a sharp blow, been dropped, or 

otherwise damaged in any way; take it 

to a qualified serviceman.

 10) Do not disassemble charger; take it to 

a qualified serviceman when service or 

repair is required. Incorrect reassembly 

may result in a risk of electric shock or 

fire.

 11) To reduce the risk of electric shock, un-

plug charger from outlet before attempt-

ing any maintenance or cleaning.

 12) The charger and battery pack are specifi-

cally designed to work together. Do not 

attempt to charge any other cordless tool 

or battery pack with this charger.

 13) Do  not attempt to charge the battery 

pack with any other charger.

 14) Do not attempt to disassemble the bat-

tery pack housing. 

 15) Do not store the tool and battery pack 

in locations where the temperature may 

reach or exceed 50°C (122°F) (such as 

a metal tool shed, or a car in the sum-

mer), which can lead to deterioration of 

the storage battery.

 16) Do  not charge battery pack when the 

temperature is BELOW 0°C (32°F)