Grizzly H0614 Leaflet
MODEL H0614/H0615
HAND CRANK
HOSE REEL
INSTRUCTIONS
To reduce the risk of injury when using this
tool:
•
Make sure the incoming air pressure
does not exceed the maximum rating
of 300 PSI. Otherwise the fittings could
crack or explode.
•
Protect your eyes by wearing safety
glasses or a face shield when assem-
bling and using this hose reel.
•
Pressurized air may cause injury to
exposed body parts. Never expose any
part of your body to pressurized air.
•
Make sure the hose reel is firmly mounted
to a stable surface before pressurizing.
Specifications
Max. Incoming Air Pressure ................... 300 PSI
Max. Hose Length on Reel for H0614 ....... 100 ft.
Max. Hose Length on Reel for H0615 ......... 50 ft.
Air Fitting Size ........................................
Max. Hose Length on Reel for H0614 ....... 100 ft.
Max. Hose Length on Reel for H0615 ......... 50 ft.
Air Fitting Size ........................................
3
⁄
8
" NPT
Inventory
Use the list below and
Figure 1 to inventory the
contents of the shipping box.
Description
Qty
A. Hose Reel Assembly (not shown) .............. 1
B. Swivel Connector
3
⁄
8
" x
3
⁄
8
" NPT ................. 1
C. Handle ........................................................ 1
D. Handle Shaft .............................................. 1
E. Lock Nut
5
⁄
16
"-18 .......................................... 1
F. Flat Washer
5
⁄
16
" ......................................... 1
Figure 1. Model H0614/H0615 small item
inventory.
B
C
D
E
F
Mounting
Use
3
⁄
8
" hardware through the four holes of the
hose reel base to firmly secure the assembly to a
convenient and stable location.
convenient and stable location.
Assembly
1. Insert the handle shaft through the handle,
then secure the assembly to the crank with
the lock nut and flat washer, as shown in
the lock nut and flat washer, as shown in
Figure 2.
Note: Use Teflon pipe tape or thread seal-
ant on all threaded connections. Also, do not
overtighten the connections or you may dam-
age the threads, resulting in leaks.
ant on all threaded connections. Also, do not
overtighten the connections or you may dam-
age the threads, resulting in leaks.
2. Install the swivel connector into the center
axle on the opposite side from handle (see
Figure 2), then connect the incoming air sup-
ply to it.
ply to it.
3. Connect the reel hose to the
3
⁄
8
" reel hose
connection shown in
Figure 2.
4. Turn the air pressure ON, then use soapy
water to test for leaks. If any are found, turn
the air pressure
the air pressure
OFF, relieve the pressure
from the hose, then repair the leaks before
putting the hose reel into operation.
putting the hose reel into operation.
Figure 2. Assembly components (Model H0614
shown).
Swivel
Connector
Handle
Reel Hose
Connection