Vector SLH100P User Manual

7

3. Disconnect the terminals and replace the battery with the same type and size

listed in the Specifications section in the back of this manual.

4. Replace the battery compartment cover and screws.
5. Turn the spotlight’s ON/OFF switch to the ON position to ensure proper

operation of spotlight.

Contains a maintenance-free, sealed, non-spillable, lead acid battery,
which must be disposed of properly. Recycling is required, contact your
local authority for information. Failure to comply with local, state and
federal regulations can result in fines, or imprisonment. For more 
information on recycling this battery, call toll-free (877) 288-7722.

• Lamp is still hot 

HID lamp power was

HID lamp can take up to 10 

and will not restart

suddenly interrupted.

minutes to reach full light power

immediately.

after a power interruption.

• Lamp will not power. Internal battery needs 

Check battery level and recharge

charging.

unit if necessary using AC or DC
charging adapters. If battery
does not take a charge, it needs 
to be replaced. Contact an 
authorized service center.

Power switch is OFF.

Turn the power switch to the ON 
position.

Unit is still charging.

Disconnect recharging adapters 
from unit and power source and 
wait five minutes before using.

• Unit will not recharge. DC plug is not 

Be sure to properly make a good

connected to the 

connection to vehicle’s accessory

vehicle.

outlet before recharging the unit.

DC plug damage

Have cord replaced by an 
authorized service center.

120 VAC charging 

Connect 120 VAC wall cube 

adapter is not 

adapter’s barrel connector to

connected to the

unit’s recharging port and then

charging port

to 120 VAC wall receptacle.

There is no power 

120 volt wall receptacle circuit

after conncecting

tripped and needs to be reset.

to 120 volt wall

If problem continues, servicing

receptacle

receptacle is advised.

SLH100P_ManualEN_091406  9/28/06  10:55 AM  Page 7